{{tag>[network cisco asa 5505]}}
=====Cisco ASA 5505 - Upgrade firmware=====
====ASA====
* Enable: enable
* Make sure there is enough space on disk0, delete for example the ADSM image. dir
delete disk0:asdm-711-52.bin
* Download new image. copy http://1.2.3.4/asa/asa904-k8.bin disk0:asa904-k8.bin
* Go into configure mode. conf t
* Show boot image. show version | i disk0
or
show running-config boot system
* Remove current boot image from config: no boot system disk0:/asa901-k8.bin
* Configure new image as boot image: boot system disk0:/asa904-k8.bin
* Save config: copy run start
* Reload: reload
====ASDM====
* Almost the same procedure as above: enable
copy http://1.2.3.4/asa/asdm-731.bin disk0:/asdm-731.bin
conf t
asdm image disk0:/asdm-731.bin
copy run start
reload
====Verify====
* Verify version numbers: sh vers | i Version
Cisco Adaptive Security Appliance Software Version 9.2(2)4
Device Manager Version 7.3(1)