{{tag>[network cisco hp]}}
=====LACP between Cisco 2960G and HP ProCurve 1810G=====
* Cisco: Port 47, 48
* HP: Port 19, 20
====HP ProCurve configuration====
* Using the web GUI, go to: Trunks -> Trunk Configuration.
* Select Create, Trunk Name **2960G**, hit 'Apply'. Notice the trunk interface name, for example **Trunk4**.
* Go to: Trunks -> Trunk Membership.
* Select Trunk4 from the drop down list.
* Select Port Trunk (M) and LACP (L) on port 19 and 20.
* Go to: VLANs -> Participation / Tagging.
* Tag needed VLANs on Trunk4. For example VLAN 50.
====Cisco 2960G configuration====
* Enable, then configure. >enable
#conf t
(config)#
* Enable LLDP. (config)#lldp run
* Create VLAN 50. (config)#vlan 50
(config-vlan)#exit
* Configure interfaces. (config)#int range Gi0/47-48
(config-if-range)#description LACP to HP 1810G
(config-if-range)#switchport nonegotiate
(config-if-range)#switchport mode trunk
(config-if-range)#lldp transmit
(config-if-range)#lldp receive
(config-if-range)#cdp enable
(config-if-range)#channel-protocol lacp
(config-if-range)#channel-group 1 mode active
Creating a port-channel interface Port-channel 1
(config-if-range)#no shutdown
(config-if-range)#exit
* Configure Port-channel. #(config)#interface Port-channel1
(config-if)#description LACP to HP 1810G
(config-if)#switchport mode trunk
(config-if)#switchport trunk allowed vlan none
(config-if)#switchport trunk allowed vlan add 50
(config-if)#no shutdown
(config-if)#exit
* Show configuration. #show interfaces Gi0/47 switchport
#show interfaces Gi0/48 switchport
#sh etherchannel summary
#sh cdp neighbors
====Configure IP address in VLAN 50 for testing====
* Configure IP address. #conf t
(config)#interface Vlan50
(config-if)#ip address 2.3.4.5 255.255.255.0