=====QRP Labs - QCX firmware upgrade with USBTinyISP=====
Using a USBTinyISP to update the QRP Labs QCX transceiver's firmware.
{{::img_3236.jpg?nolink|}}
{{:img_3235.jpg?nolink|}}
====Requirements====
* USBTinyISP with 6 pin cable.
* A built and working QCX tranceiver. Website: [[http://qrp-labs.com/qcx.html]]
* QCX Firmware [[https://www.qrp-labs.com/qcx/qcxfirmware.html]].
* Connect a dummy load.
====USBTinyISP UDev rule====
* Add the following line into file: /etc/udev/rules.d/99-USBtiny
SUBSYSTEM=="usb", ATTR{idVendor}=="1781", ATTR{idProduct}=="0c9f", GROUP="plugdev", MODE="0660"
* Plug in the USBTinyISP (or reconnect).
* Test the connection without connecting to the QCX yet:avrdude -c usbtiny -p atmega328p
avrdude: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
avrdude done. Thank you.
====Connection diagram====
* Connect the transceiver using the pinout below:
pinout USBTinyISP
+------------+
| miso vcc |
] sck mosi|
| rst gnd |
+------------+
pinout QCX
(left board edge)
| V -
| V +
|
GND | o o RESET
MOSI | o o SCK
5V | o o MISO
====Programming====
* Test connection:sudo avrdude -p atmega328p -c usbtiny -p atmega328p
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.00s
avrdude: Device signature = 0x1e950f (probably m328p)
avrdude: safemode: Fuses OK (E:FC, H:D1, L:D7)
avrdude done. Thank you.
* Program latest firmware:sudo avrdude -p atmega328p -c usbtiny -U flash:w:T1.07.hex
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.00s
avrdude: Device signature = 0x1e950f (probably m328p)
avrdude: NOTE: "flash" memory has been specified, an erase cycle will be performed
To disable this feature, specify the -D option.
avrdude: erasing chip
avrdude: reading input file "T1.07.hex"
avrdude: input file T1.07.hex auto detected as Intel Hex
avrdude: writing flash (32760 bytes):
Writing | ################################################## | 100% 39.15s
avrdude: 32760 bytes of flash written
avrdude: verifying flash memory against T1.07.hex:
avrdude: load data flash data from input file T1.07.hex:
avrdude: input file T1.07.hex auto detected as Intel Hex
avrdude: input file T1.07.hex contains 32760 bytes
avrdude: reading on-chip flash data:
Reading | ################################################## | 100% 29.58s
avrdude: verifying ...
avrdude: 32760 bytes of flash verified
avrdude: safemode: Fuses OK (E:FC, H:D1, L:D7)
avrdude done. Thank you.
{{tag>[hardware qrp labs qcx avr avrdude usbtiny usbtinyisp]}}