cisco_catalyst_2960g_-_routing
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| cisco_catalyst_2960g_-_routing [2014/08/12 14:07] – admin | cisco_catalyst_2960g_-_routing [2014/08/12 14:11] – [Cisco Catalyst 2960G - Limited routing] admin | ||
|---|---|---|---|
| Line 11: | Line 11: | ||
| * Dual: The dual IPv4 and IPv6 template allows the switch to be used in dual stack environments (supporting both IPv4 and IPv6). Using the dual stack templates results in less TCAM capacity allowed for each resource. Do not use them if you plan to forward only IPv4 traffic. | * Dual: The dual IPv4 and IPv6 template allows the switch to be used in dual stack environments (supporting both IPv4 and IPv6). Using the dual stack templates results in less TCAM capacity allowed for each resource. Do not use them if you plan to forward only IPv4 traffic. | ||
| * LAN base routing: The lanbase-routing template supports IPv4 unicast routes for configuring static routing SVIs. | * LAN base routing: The lanbase-routing template supports IPv4 unicast routes for configuring static routing SVIs. | ||
| - | * QoS—The QoS template maximizes system resources for quality of service (QoS) access control entries (ACEs). | + | * QoS: The QoS template maximizes system resources for quality of service (QoS) access control entries (ACEs). |
| **Note:** | **Note:** | ||
cisco_catalyst_2960g_-_routing.txt · Last modified: 2021/10/09 15:14 by 127.0.0.1