cisco_catalyst_2960g_-_routing
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
cisco_catalyst_2960g_-_routing [2014/08/12 14:07] โ admin | cisco_catalyst_2960g_-_routing [2014/08/14 15:21] โ [Default gateway] admin | ||
---|---|---|---|
Line 11: | Line 11: | ||
* Dual: The dual IPv4 and IPv6 template allows the switch to be used in dual stack environments (supporting both IPv4 and IPv6). Using the dual stack templates results in less TCAM capacity allowed for each resource. Do not use them if you plan to forward only IPv4 traffic. | * Dual: The dual IPv4 and IPv6 template allows the switch to be used in dual stack environments (supporting both IPv4 and IPv6). Using the dual stack templates results in less TCAM capacity allowed for each resource. Do not use them if you plan to forward only IPv4 traffic. | ||
* LAN base routing: The lanbase-routing template supports IPv4 unicast routes for configuring static routing SVIs. | * LAN base routing: The lanbase-routing template supports IPv4 unicast routes for configuring static routing SVIs. | ||
- | * QoSโThe QoS template maximizes system resources for quality of service (QoS) access control entries (ACEs). | + | * QoS: The QoS template maximizes system resources for quality of service (QoS) access control entries (ACEs). |
**Note:** | **Note:** | ||
Line 24: | Line 24: | ||
* Reload the operating system. < | * Reload the operating system. < | ||
* Verify template setting. < | * Verify template setting. < | ||
+ | |||
+ | ====Default gateway==== | ||
+ | It seems the default gateway **ip default-gateway** setting does not work for NTP. | ||
+ | * Add default gateway route < | ||
cisco_catalyst_2960g_-_routing.txt ยท Last modified: 2021/10/09 15:14 by 127.0.0.1