Ben's notes

Linux, Unix, network, radio...

User Tools

Site Tools


cisco_csr1000v

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
cisco_csr1000v [2014/08/14 09:44] – [Cisco CSR1000V / IOS XE - KVM] admincisco_csr1000v [2014/08/14 10:30] – [Cisco CSR1000V / IOS XE - KVM] admin
Line 37: Line 37:
 The current throughput level is 2500 kb/s The current throughput level is 2500 kb/s
 </code> </code>
-  * Accept the license: <code>Router>conf t+  * Cisco CSR 1000V offers a 60-day evaluation license. The evaluation license is for the Premium technology package. Accept the license: <code>Router>conf t
 #license accept end user agreement</code> #license accept end user agreement</code>
   * Configure evaluation licence. <code>#license boot level premium</code>   * Configure evaluation licence. <code>#license boot level premium</code>
Line 59: Line 59:
 </code> </code>
  
 +===Configure IP===
 +  * Show interfaces. <code>#sh ip int br
 +Interface              IP-Address      OK? Method Status                Protocol
 +GigabitEthernet1       unassigned      YES NVRAM  administratively down down    
 +GigabitEthernet2       unassigned      YES NVRAM  administratively down down    
 +GigabitEthernet3       unassigned      YES NVRAM  administratively down down    </code>
 +  * Create management VRF. <code>conf t
 +Router(config)#ip vrf mgmt-irf 
 +Router(config-vrf)#int g1           
 +Router(config-if)#ip vrf forwarding mgmt-vrf
 +Router(config-if)#^Z
  
 +#sh run int g1
 +Building configuration...
  
 +Current configuration : 105 bytes
 +!
 +interface GigabitEthernet1
 + ip vrf forwarding mgmt-vrf
 + no ip address
 + shutdown
 + negotiation auto
 +end</code>
 +  * Configure IP address. <code>conf t
 +Router(config)#int g1
 +Router(config-if)#ip add 1.2.3.4 255.255.255.0
 +Router(config-if)#no shut
 +Router(config-if)#^Z
 +
 +</code>
 +  * Show interfaces. <code>Router#sh ip int br
 +Interface              IP-Address      OK? Method Status                Protocol
 +GigabitEthernet1       192.168.42.47   YES manual up                    up      
 +GigabitEthernet2       unassigned      YES NVRAM  administratively down down    
 +GigabitEthernet3       unassigned      YES NVRAM  administratively down down    </code>
  
cisco_csr1000v.txt · Last modified: 2021/10/09 15:14 by 127.0.0.1