cisco_csr1000v
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
cisco_csr1000v [2014/08/14 09:46] – [Cisco CSR1000V / IOS XE - KVM] admin | cisco_csr1000v [2014/08/14 10:35] – [Cisco CSR1000V / IOS XE - KVM] admin | ||
---|---|---|---|
Line 59: | Line 59: | ||
</ | </ | ||
+ | ===Configure IP=== | ||
+ | * Show interfaces. < | ||
+ | Interface | ||
+ | GigabitEthernet1 | ||
+ | GigabitEthernet2 | ||
+ | GigabitEthernet3 | ||
+ | * Create management VRF. < | ||
+ | Router(config)# | ||
+ | Router(config-vrf)# | ||
+ | Router(config-if)# | ||
+ | Router(config-if)# | ||
+ | #sh run int g1 | ||
+ | Building configuration... | ||
+ | Current configuration : 105 bytes | ||
+ | ! | ||
+ | interface GigabitEthernet1 | ||
+ | ip vrf forwarding mgmt-vrf | ||
+ | no ip address | ||
+ | | ||
+ | | ||
+ | end</ | ||
+ | * Configure IP address. < | ||
+ | Router(config)# | ||
+ | Router(config-if)# | ||
+ | Router(config-if)# | ||
+ | Router(config-if)# | ||
+ | </ | ||
+ | * Show interfaces. < | ||
+ | Interface | ||
+ | GigabitEthernet1 | ||
+ | GigabitEthernet2 | ||
+ | GigabitEthernet3 | ||
+ | * Ping test. < | ||
+ | Type escape sequence to abort. | ||
+ | Sending 5, 100-byte ICMP Echos to 1.2.3.2, timeout is 2 seconds: | ||
+ | .!!!! | ||
+ | Success rate is 80 percent (4/5), round-trip min/avg/max = 1/2/4 ms</ |
cisco_csr1000v.txt · Last modified: 2021/10/09 15:14 by 127.0.0.1