Ben's notes

Linux, Unix, network, radio...

User Tools

Site Tools


cisco_csr1000v

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Last revisionBoth sides next revision
cisco_csr1000v [2014/08/14 10:30] – [Cisco CSR1000V / IOS XE - KVM] admincisco_csr1000v [2014/08/14 10:35] – [Cisco CSR1000V / IOS XE - KVM] admin
Line 91: Line 91:
   * Show interfaces. <code>Router#sh ip int br   * Show interfaces. <code>Router#sh ip int br
 Interface              IP-Address      OK? Method Status                Protocol Interface              IP-Address      OK? Method Status                Protocol
-GigabitEthernet1       192.168.42.47   YES manual up                    up      +GigabitEthernet1       1.2.3.4         YES manual up                    up      
 GigabitEthernet2       unassigned      YES NVRAM  administratively down down     GigabitEthernet2       unassigned      YES NVRAM  administratively down down    
 GigabitEthernet3       unassigned      YES NVRAM  administratively down down    </code> GigabitEthernet3       unassigned      YES NVRAM  administratively down down    </code>
 +  * Ping test. <code>Router#ping vrf mgmt-vrf 1.2.3.2 
 +Type escape sequence to abort. 
 +Sending 5, 100-byte ICMP Echos to 1.2.3.2, timeout is 2 seconds: 
 +.!!!! 
 +Success rate is 80 percent (4/5), round-trip min/avg/max = 1/2/4 ms</code>
cisco_csr1000v.txt · Last modified: 2021/10/09 15:14 by 127.0.0.1