hp_parity_initialization_status_-_in_progress
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
hp_parity_initialization_status_-_in_progress [2014/01/15 09:24] – admin | hp_parity_initialization_status_-_in_progress [2014/01/15 09:45] – admin | ||
---|---|---|---|
Line 20: | Line 20: | ||
</ | </ | ||
- | Try to set the " | + | * First upgrade the firmware and your hpacucli version. The problem might then be resolved! |
+ | * If not, then try the following: | ||
The surface scan delay is the time interval before surface scan analysis activates. This time does not begin counting until there are no commands being sent to the controller. Surface scan analysis is a background process that scans hard drives for bad sectors in fault tolerant logical drives. In RAID 5 or RAID ADG configurations, | The surface scan delay is the time interval before surface scan analysis activates. This time does not begin counting until there are no commands being sent to the controller. Surface scan analysis is a background process that scans hard drives for bad sectors in fault tolerant logical drives. In RAID 5 or RAID ADG configurations, | ||
hp_parity_initialization_status_-_in_progress.txt · Last modified: 2021/10/09 15:14 by 127.0.0.1