Ben Stienstra

Linux, Unix, network, radio and more...

User Tools

Site Tools


hp_parity_initialization_status_-_in_progress

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
hp_parity_initialization_status_-_in_progress [2014/01/15 10:35]
admin
hp_parity_initialization_status_-_in_progress [2014/01/15 10:45]
admin
Line 20: Line 20:
 </​code>​ </​code>​
  
-Try to set the "​Surface Scan Analysis Priority"​ to "​High"​. ​+  * First upgrade the firmware and your hpacucli version. The problem might then be resolved! 
 +  * If not, then try the following: ​set the "​Surface Scan Analysis Priority"​ to "​High"​. ​
  
 The surface scan delay is the time interval before surface scan analysis activates. This time does not begin counting until there are no commands being sent to the controller. Surface scan analysis is a background process that scans hard drives for bad sectors in fault tolerant logical drives. In RAID 5 or RAID ADG configurations,​ surface scan also verifies the consistency of parity data. This process assures that you can recover all data successfully if a drive failure occurs in the future. The possible value is 1-30 seconds. ​ The surface scan delay is the time interval before surface scan analysis activates. This time does not begin counting until there are no commands being sent to the controller. Surface scan analysis is a background process that scans hard drives for bad sectors in fault tolerant logical drives. In RAID 5 or RAID ADG configurations,​ surface scan also verifies the consistency of parity data. This process assures that you can recover all data successfully if a drive failure occurs in the future. The possible value is 1-30 seconds. ​
  
hp_parity_initialization_status_-_in_progress.txt · Last modified: 2014/06/10 14:20 by admin