qrp_labs_qcx_firmware
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
qrp_labs_qcx_firmware [2019/06/02 18:58] – [Configure raspbian] admin | qrp_labs_qcx_firmware [2019/10/12 10:29] – admin | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | =====QRP Labs - QCX firmware upgrade===== | + | =====QRP Labs - QCX firmware upgrade |
- | 2019-06-02 - Using a Raspberry Pi as AVR programmer. I connected it with power on the QCX, did not use the 5V supply from the Raspberry Pi. | + | 2019-10-12 - Using a Raspberry Pi as AVR programmer. |
{{: | {{: | ||
====Requirements==== | ====Requirements==== | ||
- | * Raspberry Pi (I used a model B+ V1.2 board from 2014). | + | * Raspberry Pi (I used a 3 model B+ board from 2017). |
+ | * Raspbian (based on Debian Buster) | ||
* Built and working QCX tranceiver. Website: [[http:// | * Built and working QCX tranceiver. Website: [[http:// | ||
* Jumper wires. | * Jumper wires. | ||
Line 12: | Line 13: | ||
* Enable spi < | * Enable spi < | ||
- | * Install avrdude:< | + | * Install avrdude:< |
====Wiring==== | ====Wiring==== |
qrp_labs_qcx_firmware.txt · Last modified: 2021/10/09 15:14 by 127.0.0.1