qrp_labs_qcx_firmware
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
qrp_labs_qcx_firmware [2019/10/12 10:31] – admin | qrp_labs_qcx_firmware [2019/10/12 13:06] – [Programming] admin | ||
---|---|---|---|
Line 1: | Line 1: | ||
=====QRP Labs - QCX firmware upgrade with Raspberry Pi===== | =====QRP Labs - QCX firmware upgrade with Raspberry Pi===== | ||
- | <color # | + | 2019-10-12 - Using a Raspberry Pi board as AVR programmer to update the QRP Labs QCX transceiver' |
- | 2019-10-12 - Using a Raspberry Pi as AVR programmer to update the QRP Labs QCX transceiver. | + | {{:: |
- | {{:img_1746.jpg? | + | {{::img_2155.jpg? |
====Requirements==== | ====Requirements==== | ||
* Raspberry Pi (I used a 3 model B+ board from 2017). | * Raspberry Pi (I used a 3 model B+ board from 2017). | ||
- | * Raspbian (based on Debian Buster) | + | * Raspbian (based on Debian Buster). Using ''/ |
- | * Built and working QCX tranceiver. Website: [[http:// | + | * A built and working QCX tranceiver. Website: [[http:// |
* Jumper wires. | * Jumper wires. | ||
+ | * QCX Firmware [[https:// | ||
====Configure raspbian==== | ====Configure raspbian==== | ||
- | * Enable spi < | + | * Enable spi in ''/ |
* Install avrdude:< | * Install avrdude:< | ||
Line 21: | Line 22: | ||
< | < | ||
- | ============ | + | |
Raspberry Pi | Raspberry Pi | ||
- | ============ | + | ========================================= |
- | BCM 9 | + | (Right board edge) |
- | BCM 10 (MOSI) | + | | |
- | BCM 11 (SCLK) | + | 1 oo|2 |
- | BCM 25 (RESET) | + | 3 oo|4 |
- | Ground | + | 5 oo|6 |
+ | 7 oo|8 | ||
+ | 9 oo|10 | ||
+ | 11 oo|12 | ||
+ | 13 oo|14 | ||
+ | 15 oo|16 | ||
+ | 17 oo|18 | ||
+ | BCM 10 MOSI - 19 oo|20 | ||
+ | BCM 9 MISO - 21 oo|22 BCM 25 RESET | ||
+ | BCM 11 SCLK - 23 oo|24 | ||
+ | GND - 25 oo|26 | ||
+ | < | ||
+ | |||
- | ============ | ||
QCX | QCX | ||
- | ============ | + | ========================================= |
(left board edge) | (left board edge) | ||
Line 46: | Line 59: | ||
</ | </ | ||
- | ====programming==== | + | ====Programming==== |
* Check connection:< | * Check connection:< | ||
- | * Program latest firmware:< | + | * Program latest firmware:< |
qrp_labs_qcx_firmware.txt · Last modified: 2021/10/09 15:14 by 127.0.0.1