Differences

This shows you the differences between two versions of the page.

--- qrp_labs_qcx_firmware [2020/03/16 21:04] – admin
+++ qrp_labs_qcx_firmware [2021/01/09 09:53] – admin
@@ Line 1: / Line 1: @@
 =====QRP Labs - QCX firmware upgrade with Raspberry Pi=====
+**<color #ed1c24>I now use the: [[qcx_firmware_usbtinyisp|USBTinyISP]] method.</color>**
 Using a Raspberry Pi board as AVR programmer to update the QRP Labs QCX transceiver's firmware. The power draw from the QCX to the RPi seemed a bit too much, so I did not use the RPi 5v output.
 {{::img_2158.jpg?nolink&600|}} \\
-//Photo of older version firmware.//
+//Photo of older version firmware, i'm now at v1.05.//
 {{::img_2155.jpg?nolink&600|}}
@@ Line 14: / Line 16: @@
   * Jumper wires.
   * QCX Firmware [[https://www.qrp-labs.com/qcx/qcxfirmware.html]].
-  * Connect a dummy load!
+  * **Connect a dummy load! I did see a unit going into transmit when connected to the RPi, during flashing transmit was off. I haven't investigated how and why this happens.**
 ====Configure raspbian====