Differences

This shows you the differences between two versions of the page.

--- versalogic_vl-mpeu-g2_ntp [2014/06/21 18:49] – [PC Engines APU / Versalogic - NTP server] admin
+++ versalogic_vl-mpeu-g2_ntp [2014/06/21 19:11] – [Configure, firmware update ublox NEO-7 module] admin
@@ Line 194: / Line 194: @@
 ===Recommended settings for timing applications===
   * SBAS -> Subsystem: Disabled.
-  * (not supported on u-blox 7) TMODE2 -> Survey-in. If the position is known, the receiver can provide an accurate time solution by tracking only one satellite. For an unknown position, the receiver needs a minimum of four satellites to calculate a position fix and to solve for a timing solution. This is known as survey-in and can be chosen using the UBX-CFG-TMODE2 message. It is recommended to use survey-in only for non-moving platform applications. For optimal performance a known fixed position of the antenna should be used.
+  * (not supported by u-blox 7) TMODE2 -> Survey-in. If the position is known, the receiver can provide an accurate time solution by tracking only one satellite. For an unknown position, the receiver needs a minimum of four satellites to calculate a position fix and to solve for a timing solution. This is known as survey-in and can be chosen using the UBX-CFG-TMODE2 message. It is recommended to use survey-in only for non-moving platform applications. For optimal performance a known fixed position of the antenna should be used.
   * NAV5 -> Dynamic Model: Stationary
   * NAV5 -> Min SV Elevation: 10
   * Save config, restart receiver. Receiver -> Action -> Cold start